Differences

This shows you the differences between two versions of the page.

--- devices:pollux:didj-fi [2020/05/26 21:04] – jkent
+++ devices:pollux:didj-fi [2020/06/06 22:57] (current) – [Didj-Fi NAND] jkent
@@ Line 18: / Line 18: @@
 |Clockwise        |None (RAM)    |
-**Note**: For the Leapster Explorer and LeapPad Explorer 1 you must [[devices:pollux:boot_modification|make some modifications]] to the device for UART and NAND boot modes to work.
+**Note**: For the Leapster Explorer and LeapPad Explorer 1 you must [[devices:pollux:boot_modification|make some modifications]] to the device for UART boot to work.
 <clear>
@@ Line 28: / Line 28: @@
   * 4-pin serial header
   * Solder jumpers for boot mode
+**Note**: The v1.0 silkscreen table is backwards in regards to the Cartridge and Internal NAND boot options. Please use the below table.
 Boot mode solder jumpers:
@@ Line 34: / Line 36: @@
 |  X  |  X  |  X  |Device default|
 |  X  |  0  |  0  |UART          |
-|  0  |  0  |  1  |Internal NAND |
+|  0  |  0  |  1  |Cartridge NAND|
-|  1  |  0  |  1  |Cartridge NAND|
+|  1  |  0  |  1  |Internal NAND |
 |  X  |  1  |  1  |None (RAM)    |
-**Note**: For the Leapster Explorer and LeapPad Explorer 1 you must [[devices:pollux:boot_modification|make some modifications]] to the device for UART boot to work.
+**Note**: For the Leapster Explorer and LeapPad Explorer 1 you must [[devices:pollux:boot_modification|make some modifications]] to the device for UART and NAND boot modes to work.